1. Place the drying oven at the level of the drying room without corrosive gas.
2. The power input should be equipped with a special front-stage on-off switch, and connect a good ground wire to ensure safety.
3. Check the power supply voltage, and the power supply can be used only after the power supply wiring is correct.
4. When newly purchased and used or shelved for a long time, it should be baked at low temperature (80-100 °C) for two hours before starting to raise the temperature to facilitate moisture leakage, enhance menopause performance and prolong the life of porcelain.
5. The thermal element probe of instrument temperature control should be inserted into the working room from the temperature measurement hole of the left line layer, and should not be inserted from the center hole of the air valve at the top of the box, so as not to affect the use.
6. The drying oven baking effect is better, when using it for the first time, you should observe it frequently to avoid losses caused by overheating and baking.
7. If you feel that the thermal inertia is slightly larger during use, you can turn off a group of heaters to reduce the heating power and prevent excessive inertia from causing overtemperature.
8. Take out the baking object, do not hit the part of the thermostat that extends into the studio to prevent damage to the thermostat and cause failure.
9. In case of failure, please professional electrician for maintenance.
10. One certificate of conformity for each of the two manuals of the studio shelf when leaving the factory.
11. This oven should not bake explosive, flammable and pressing items to prevent explosion.
